Share:


The influence of feed rate on surface roughness of TIC–WC carbide and Al2O3 ceramics SAWN-OFF with inner edge of diamond disc

Abstract

The paper presents results of measurements of surface roughness of titanium-tungsten carbide (T14K8) and aluminium oxide (Al2O3) ceramics surfaces sawn-off with inner edge of diamond disc. The cutting process was performed by cutting machine “АЛМАЗ-4” with 60/40 grain size disc. The dependence of average roughness Ra of the sawn-off surface on feed speed of the workpiece was established.


Article in Lithuanian.


Pastūmos įtaka TIC–WC kietlydinio ir AL2O3 keramikos paviršiaus šiurkštumui pjaunant vidine deimantinio disko briauna


Santrauka. Straipsnyje pateikti dvikarbidžio (titano ir volframo karbidų T14K8) kietlydinio ir aliuminio oksido keramikos paviršiaus vidutinio aritmetinio profilio nuokrypio matavimo rezultatai, kai šių medžiagų paviršiai buvo formuojami pjaunant bandinius vidine deimantinio disko briauna esant skirtingoms pastūmoms. Pjauta staklėmis „Алмаз-4“ deimantiniu disku, kurio grūdėtumas – 60/40. Profilometru matuojant šiurkštumą nustatyta kietlydinio T14K8 ir Al2O3 keramikos paviršiaus vidutinio aritmetinio profilio nuokrypio priklausomybė nuo pastūmos greičio.


Reikšminiai žodžiai: kietlydinys, aliuminio oksido keramika, vidutinis aritmetinis profilio nuokrypis, deimantinis diskas

Keyword : carbide, aluminium oxide ceramics, diamond disc

How to Cite
Mikolaitis, R., Bukauskas, V., Mokšin, V., & Striška, V. (2010). The influence of feed rate on surface roughness of TIC–WC carbide and Al2O3 ceramics SAWN-OFF with inner edge of diamond disc. Mokslas – Lietuvos Ateitis / Science – Future of Lithuania, 2(4), 88-90. https://doi.org/10.3846/mla.2010.078
Published in Issue
Aug 31, 2010
Abstract Views
418
PDF Downloads
211
Creative Commons License

This work is licensed under a Creative Commons Attribution 4.0 International License.